Made some improvements to the MFOS Sound Lab and Arduino Sequencer last night:
1. Actually connected the Sound Lab CV inputs and audio output to the correct jack connectors. CV works now! Audio works better – it had been making audio output, but it just seemed thin and quiet. That’s no longer the case!
2. Ran the CV output of the Arduino Sequencer through this low-pass filter design. Hopefully that’ll smooth things a bit.
3. Started on the S-trig gate output for the sequencer.
Near-term plans:
1. Finish the S-trig gate output.
2. Slice off about 1/4″-1/2″ of the Sound Lab front panel, so that it fits the scanner chassis I’m putting it in.
3. Add note length and transpose controls to the sequencer.
4. Make a better demo video.